| 원통 봉을 적용한 압전 캔틸레버의 성능 향상 |
| 이영진, 김세기, 김영득1 |
한국세라믹기술원 전자소재.모듈팀
1한양대학교 기계공학과 |
| Improved Power Output by a Piezoelectric Cantilever after Addition of a Cylindrical Bar |
| Youngjin Lee, Seiki Kim, Young-Deuk Kim1 |
Electronic Materials & Module Team, Korea Institute of Ceramic Engineeing & Technolongy
1Department of Mechanical Engineering, Hanyang University |
|
|
|
|
|
| ABSTRACT |
|
This paper describes the development of a new piezoelectric unimorph cantilever structure intended to improve electrical output power, compared to a conventional cantilever. The proposed structure employs a cylindrical bar attached to one side of a steel plate, which is a significant factor in forced vibration mode. The feasibility of the proposed methodology was assessed experimentally and theoretically. The influence of three different types of bar material (i.e., stainless steel, silicon rubber, and urethane), and bar position, on the output voltage were examined and compared with those without the bar. The optimal position and material for the bar were identified through experimental and theoretical analyses. It appears that the electrical output power of the proposed cantilever is about 40% higher than that of a conventional unimorph cantilever. |
| Key words:
Piezoelectric transducer, Cantilever, FEM, Boundary condition |
|
|
|
PDF Links
Full text via DOI
Download Citation 
